Which webcams are supported by the various PCoIP host/client configurations?
Please note that some webcam models have been found to contain different hardware within the same model (possibly identified by a hardware revision number), causing these webcams to behave differently when connected to a PCoIP Zero Client. Ensure to test …
Knowledge Base Article Advisory Peripheral Devices Zero Clients
Last modified: September 20, 2023
7195
Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4876
What are the requirements for USB 2.0 (EHCI) support on PCoIP Zero Clients?
Answer: EHCI (Enhanced Host Controller Interface) is a high-speed controller standard that is publicly documented and provides high speed USB functionality. Tera2 based PCoIP Clients support USB 2.0 (EHCI) out of the box on all firmware releases. The …
Knowledge Base Article Advisory Peripheral Devices Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3672
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3519