What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
610
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
595
Why does my PCoIP Remote Workstation hibernate or sleep and not power off remotely from my Tera 2 PCoIP Zero Client?
When a PCoIP Zero Client attempts to power down a Windows 7 or Windows 10 workstation host during a PCoIP session, the workstation may enter the sleep state rather than being shutdown. This will occur if Windows is configured to map the PC power button to …
Knowledge Base Article Advisory Session Remote Workstation Card Zero Clients
Last modified: July 3, 2020
513
What are the cabling requirements in a Remote Workstation Card environment?
Answer: HP Anyware PCoIP Remote Workstation Cards and PCoIP Zero Clients are designed considering port pass through and should be connected in a specific manner to limit potential display issues. In a PCoIP workstation environment ensure the connection …
Knowledge Base Article Advisory Display Remote Workstation Card
Last modified: August 2, 2023
441
Should I configure "Maximum Initial Image Quality" to 100 if I want lossless still image?
No. Regardless of PCoIP image-quality settings, still images are always lossless. The time it takes to display them depends on your image-quality settings and available network bandwidth. For most situations, it is recommended to use 40 for Minimum Image …
Knowledge Base Article Advisory Performance Display Remote Workstation Card HP Anyware Zero Clients
Last modified: December 9, 2022
364
Could the use of two DVI channels be a sources for delay which might cause jitter in a PCoIP Remote Workstation Card configuration?
Using the two DVI channels on a PCoIP Zero Client to PCoIP Remote Workstation Card with the Dual-link DVI connector converter to achieve a 2560x1600 resolution is NOT a source for delay which might cause jitter. The use of two DVI channels could be one of …
Knowledge Base Article Advisory Performance Display Remote Workstation Card Zero Clients
Last modified: July 3, 2020
208
Why are some resolutions not available in the OSD but are listed as available in the PCoIP Zero Client Administrator's Guide?
This article is applicable to PCoIP Zero Clients that have DVI ports. To see all the supported resolutions in the OSD as listed in the PCoIP Zero Client Administrators' Guide ( GUI Reference > Configuring OSD Display Settings > OSD Dual-display: Display …
Knowledge Base Article Advisory Display Zero Clients
Last modified: September 3, 2023
115