In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Answer: 2560x1440 and 2560x1600 resolutions share the same cable requirements. Review and follow the instructions for connectors and cables in Dual-link DVI, Single-link DVI, DisplayPort and 2560x1600 resolutions with PCoIP products. . To get a 2560x1440 …
PCoIP Zero Clients support multi-factor authentication when connecting to HP Anyware, PCoIP Remote Workstation Cards, VMware or Amazon WorkSpaces. These can be used in pre-session authentication and in-session/post-session authentication scenarios. Since …
Problem You cannot establish a PCoIP session using your smart card in pre-session with a PCoIP Zero Client, but you are successful when using a VMware Horizon client. Note: Make sure that your smartcard and smartcard reader meet the requirements listed …
Whenever an image that is sent to a remote client is not pixel exact, it is considered lossy rather than lossless. The human eye is not always able to perceive these lossy differences. For example, the human eye is much less sensitive to errors in the …
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …
Answer: Monitor emulation is a feature on the PCoIP Remote Workstation Card (also known as a host card) that ensures graphics cards see a valid EDID on a Display Port or DVI port on boot. This helps prevent the graphics card from driving DVI signals or DP …
Multi-factor authentication systems are supported by Teradici Products. Examples of multi-factor authentication systems are RSA SecurID and Duo. HP Anyware Manager supports multi-factor authentication as secondary authentication via a radius server. …
Answer: PCoIP Zero Clients support selected ELO touch monitors in pre-session (using the Teradici OSD) since Firmware 3.4.0,and should support other touchscreen monitors (single and multi-touch) while in a PCoIP session. To make a connection using a …