How to use the HP Anyware Licensing Portal
The HP Anyware Licensing Portal provides secure access to the list of licenses and can be used by the company's assigned Account Administrator. The Account Administrator role can be fulfilled by one central administrator or can be distributed across …
Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Steps for doing an Offline License Activation/Deactivation for Management Console
For offline activation, you will need some assistance from the HP Anyware technical staff. Scenario 1:   Fresh license activation : Login into your account on the  HP Anyware self service portal .  Don't have an account? Register  here . Select  …
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Do PCoIP Zero Clients support multi-factor authentication?
PCoIP Zero Clients support multi-factor authentication when connecting to HP Anyware, PCoIP Remote Workstation Cards, VMware or Amazon WorkSpaces. These can be used in pre-session authentication and in-session/post-session authentication scenarios. Since …
Why does my pre-session smart card authentication fail with my PCoIP Zero Client but not my VMware Horizon client?
Problem You cannot establish a PCoIP session using your smart card in pre-session with a PCoIP Zero Client, but you are successful when using a VMware Horizon client. Note: Make sure that your smartcard and smartcard reader meet the requirements listed …