Should I configure "Maximum Initial Image Quality" to 100 if I want lossless still image?
No. Regardless of PCoIP image-quality settings, still images are always lossless. The time it takes to display them depends on your image-quality settings and available network bandwidth. For most situations, it is recommended to use 40 for Minimum Image …
Knowledge Base Article Advisory Performance Display Remote Workstation Card HP Anyware Zero Clients
Last modified: December 9, 2022
372
Error: PCoIP Agent has no available licenses to launch the remote session
Symptom Remote desktops that were previously registered with HP Anyware Cloud License Server (CLS) may get the following client message when trying to connect: “Error – PCoIP Agent has no available licenses to launch the remote session.” In the Anyware …
Knowledge Base Article Advisory Troubleshooting Licensing HP Anyware
Last modified: September 3, 2023
273
Can I use Cisco Express Forwarding per-packet load sharing with PCoIP Protocol?
No, Cisco Express Forwarding (CEF) per-packet load sharing causes out-of-order packets which is not compatible with real-time protocols such as PCoIP Protocol.  Cisco has similar recommendations against CEF per-packet load sharing when using Voice-over-IP …
Knowledge Base Article Advisory Performance Third Party Enhancements HP Anyware
Last modified: September 3, 2023
239
Could the use of two DVI channels be a sources for delay which might cause jitter in a PCoIP Remote Workstation Card configuration?
Using the two DVI channels on a PCoIP Zero Client to PCoIP Remote Workstation Card with the Dual-link DVI connector converter to achieve a 2560x1600 resolution is NOT a source for delay which might cause jitter. The use of two DVI channels could be one of …
Knowledge Base Article Advisory Performance Display Remote Workstation Card Zero Clients
Last modified: July 3, 2020
208
Why are some resolutions not available in the OSD but are listed as available in the PCoIP Zero Client Administrator's Guide?
This article is applicable to PCoIP Zero Clients that have DVI ports. To see all the supported resolutions in the OSD as listed in the PCoIP Zero Client Administrators' Guide ( GUI Reference > Configuring OSD Display Settings > OSD Dual-display: Display …
Knowledge Base Article Advisory Display Zero Clients
Last modified: September 3, 2023
118
Recommend upgrading LLS 21.03 or earlier to the latest LLS to avoid service disruption
Our third-party license provider is upgrading certificates in March 2023 If you are running a  supported  HP Anyware Local License Server (LLS) or using the Cloud License Service (CLS), you will not be impacted by these changes.  The new certificates are …
Knowledge Base Article Advisory Tutorial Licensing HP Anyware
Last modified: July 10, 2023
61