What is the session disconnect timeout for a PCoIP session?
Answer: A PCoIP protocol session is disconnected after a period of network inactivity that is dependent on the client type and configuration settings. This includes settings for: PCoIP Zero Clients: 30 seconds (default) of no network communication PCoIP …
Knowledge Base Article Advisory Session HP Anyware Remote Workstation Card Zero Clients
Last modified: October 17, 2023
4016
What is an acceptable level of packet loss?
Just like VoIP and video conferencing, PCoIP is a real time protocol. Once a packet is lost in transit, there typically isn't time to re transmit before the PCoIP session is impacted. Therefore, the most acceptable level of loss is 0%. Packet loss maybe …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2749
How much latency does PCoIP technology add to the remote system?
The latency added by PCoIP technology to a remote system is related to the time to encode (compression) and decode (decompression) for the PCoIP protocol, which depends on the implementation. Total end-to-end latency is determined by OS latency and …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: July 28, 2023
1356
What does the error message "Session Closed Remotely" mean?
There are a number or reasons that the message "Session Closed Remotely" appears during a brokered session listed below. Informational Messages Closed by login at an alternate location or host shutdown/restart User initiated logout Disconnected by …
Knowledge Base Article Advisory Session HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
990
What network switch or router queue size should be used?
Network device queues, also known as network buffer's, should be configured to accommodate 50ms to 100ms of PCoIP protocol traffic in total. This assumes that one network device (e.g. switch or router) is congested for a given network path. If the network …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 19, 2023
639
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
615
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
597