Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

Answer There are several ways to reset the password for zero clients. Option 1: Use Management Console For enterprise users, the PCoIP Management Console is recommended to manage the zero client security options including password reset etc. Please …

USB and Analog audio through PCoIP Zero Clients

This knowledge base article explains analog and USB audio behavior in PCoIP environments. When a USB audio device is used without the local USB audio driver enabled, the USB audio device is remotely bridged to the host. In this case, the audio stream data …

Which webcams are supported by the various PCoIP host/client configurations?

Please note that some webcam models have been found to contain different hardware within the same model (possibly identified by a hardware revision number), causing these webcams to behave differently when connected to a PCoIP Zero Client. Ensure to test …

What does the status of attached USB devices mean in the AWI?

In the Administrator Web Interface (AWI) of the PCoIP Zero Client you can review the status of any attached device ( i.e. monitors, usb ). The status of the device is as follows: Disconnected or Not Connected - no device connected to a display port. …

What is the session disconnect timeout for a PCoIP session?

Answer: A PCoIP protocol session is disconnected after a period of network inactivity that is dependent on the client type and configuration settings. This includes settings for: PCoIP Zero Clients: 30 seconds (default) of no network communication PCoIP …

What are the requirements for USB 2.0 (EHCI) support on PCoIP Zero Clients?

Answer: EHCI (Enhanced Host Controller Interface) is a high-speed controller standard that is publicly documented and provides high speed USB functionality. Tera2 based PCoIP Clients support USB 2.0 (EHCI) out of the box on all firmware releases. The …

Do PCoIP Zero Clients support multi-factor authentication?

PCoIP Zero Clients support multi-factor authentication when connecting to HP Anyware, PCoIP Remote Workstation Cards, VMware or Amazon WorkSpaces. These can be used in pre-session authentication and in-session/post-session authentication scenarios. Since …

Can multi-factor authentication be used with PCoIP?

Multi-factor authentication systems are supported by Teradici Products. Examples of multi-factor authentication systems are RSA SecurID and Duo. HP Anyware Manager supports multi-factor authentication as secondary authentication via a radius server. …

How to change the Num Lock setting on a PCoIP Zero Client

The num lock ( numlock) setting depends on whether the PCoIP Zero Client is at the On-Screen-Display (OSD) or when in-session. On-Screen-Display operation The "Factory" default setting of num lock can be set by the PCoIP Zero Client OEM during …

Why PCoIP Zero Clients cannot operate at USB 2.0 speeds of 480Mbits/s?

The most common cause of slow USB data transfers is related to the network environment.USB data transfers are sensitive to the available network bandwidth, latency, and packet loss. Following are the few reasons that can cause the reduction in …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics