Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

USB and Analog audio through PCoIP Zero Clients

This knowledge base article explains analog and USB audio behavior in PCoIP environments. When a USB audio device is used without the local USB audio driver enabled, the USB audio device is remotely bridged to the host. In this case, the audio stream data …

Which webcams are supported by the various PCoIP host/client configurations?

Please note that some webcam models have been found to contain different hardware within the same model (possibly identified by a hardware revision number), causing these webcams to behave differently when connected to a PCoIP Zero Client. Ensure to test …

What is the session disconnect timeout for a PCoIP session?

Answer: A PCoIP protocol session is disconnected after a period of network inactivity that is dependent on the client type and configuration settings. This includes settings for: PCoIP Zero Clients: 30 seconds (default) of no network communication PCoIP …

What does the status of attached USB devices mean in the AWI?

In the Administrator Web Interface (AWI) of the PCoIP Zero Client you can review the status of any attached device ( i.e. monitors, usb ). The status of the device is as follows: Disconnected or Not Connected - no device connected to a display port. …

What are the requirements for USB 2.0 (EHCI) support on PCoIP Zero Clients?

Answer: EHCI (Enhanced Host Controller Interface) is a high-speed controller standard that is publicly documented and provides high speed USB functionality. Tera2 based PCoIP Clients support USB 2.0 (EHCI) out of the box on all firmware releases. The …

How to change the Num Lock setting on a PCoIP Zero Client

The num lock ( numlock) setting depends on whether the PCoIP Zero Client is at the On-Screen-Display (OSD) or when in-session. On-Screen-Display operation The "Factory" default setting of num lock can be set by the PCoIP Zero Client OEM during …

Why PCoIP Zero Clients cannot operate at USB 2.0 speeds of 480Mbits/s?

The most common cause of slow USB data transfers is related to the network environment.USB data transfers are sensitive to the available network bandwidth, latency, and packet loss. Following are the few reasons that can cause the reduction in …

What USB CD/DVD drives should I consider using with PCoIP Zero Clients?

Teradici does not maintain a list of tested units. With the introduction of EHCI (USB 2) functionality, compatibility with currently manufactured DVD brands has improved greatly, particularly when the PCoIP Zero Client or PCoIP Remote Workstation Card …

USB Network Hub Option for High-Speed USB 2.0 Peripherals

Scenario Tera1 PCoIP Zero Clients with firmware 3.5.0 or newer supports up to 3x the USB transfer rate of previous firmware builds. If additional USB bandwidth is required then consider: Using Tera2 based PCoIP Zero Clients Using an external USB network …

What does the error message "Session Closed Remotely" mean?

There are a number or reasons that the message "Session Closed Remotely" appears during a brokered session listed below. Informational Messages Closed by login at an alternate location or host shutdown/restart User initiated logout Disconnected by …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics