Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3060
What is an acceptable level of packet loss?
Just like VoIP and video conferencing, PCoIP is a real time protocol. Once a packet is lost in transit, there typically isn't time to re transmit before the PCoIP session is impacted. Therefore, the most acceptable level of loss is 0%. Packet loss maybe …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2733
Do PCoIP Zero Clients support multi-factor authentication?
PCoIP Zero Clients support multi-factor authentication when connecting to HP Anyware, PCoIP Remote Workstation Cards, VMware or Amazon WorkSpaces. These can be used in pre-session authentication and in-session/post-session authentication scenarios. Since …
Knowledge Base Article Advisory Authentication Security HP Anyware Zero Clients
Last modified: September 21, 2023
2622
Why does my pre-session smart card authentication fail with my PCoIP Zero Client but not my VMware Horizon client?
Problem You cannot establish a PCoIP session using your smart card in pre-session with a PCoIP Zero Client, but you are successful when using a VMware Horizon client. Note: Make sure that your smartcard and smartcard reader meet the requirements listed …
Knowledge Base Article Advisory Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
2596
Is a 2560x1600 display resolution supported by PCoIP hardware devices?
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2499
Tera 1 PCoIP Zero Client or PCoIP Remote Workstation card firmware prerequisites when upgrading to new firmware releases.
Answer: Note: HP Anyware Tera 1 PCoIP Zero Client devices and firmware are End of Life. Whist Tera 1 based PCoIP Zero Clients can be upgraded to Firmware 4.7.1 they lack many of the modern security standards for network communication. It is recommended …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2484
Workaround for database failures when restoring or migrating from PCoIP Management Console 2.4 or older to versions 2.5.1 or newer.
Customers on Management Console (MC) 2.4 or older, restoring databases, or migrating to 2.5.1 or newer are required to run this mandatory database clean-up script prior to the restore or migration. These steps reduce the size of the database which is …
Knowledge Base Article Advisory Management Setup Management Console
Last modified: September 3, 2023
2473
What are the factory default network settings for PCoIP Zero Clients and PCoIP Remote Workstation Cards?
Answer: An OEM may change the factory default network settings. Please refer to your OEM's manual for detailed information. Most devices generally have the following factory default network settings: DHCP enabled Fallback IP address (PCoIP Remote …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2204