Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4896
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3562
Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3080
Where can I find a PCoIP-compatible connection broker?
In additional to HP Anyware Manager, as part of the Technology Partner Program, HP Anyware enables companies to build support for PCoIP session brokering. The following is a list of PCoIP compatible connection brokers:   Company Product Compatible with …
Knowledge Base Article Advisory Session Setup HP Anyware Remote Workstation Card
Last modified: September 25, 2023
2732
Is a 2560x1600 display resolution supported by PCoIP hardware devices?
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2509
Tera 1 PCoIP Zero Client or PCoIP Remote Workstation card firmware prerequisites when upgrading to new firmware releases.
Answer: Note: HP Anyware Tera 1 PCoIP Zero Client devices and firmware are End of Life. Whist Tera 1 based PCoIP Zero Clients can be upgraded to Firmware 4.7.1 they lack many of the modern security standards for network communication. It is recommended …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2495
What are the factory default network settings for PCoIP Zero Clients and PCoIP Remote Workstation Cards?
Answer: An OEM may change the factory default network settings. Please refer to your OEM's manual for detailed information. Most devices generally have the following factory default network settings: DHCP enabled Fallback IP address (PCoIP Remote …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2215
What is monitor emulation on the PCoIP Remote Workstation Card and how does it work?
Answer: Monitor emulation is a feature on the PCoIP Remote Workstation Card (also known as a host card) that ensures graphics cards see a valid EDID on a Display Port or DVI port on boot. This helps prevent the graphics card from driving DVI signals or DP …
Knowledge Base Article Advisory Display Setup Remote Workstation Card
Last modified: September 3, 2023
2210