How much latency does PCoIP technology add to the remote system?
The latency added by PCoIP technology to a remote system is related to the time to encode (compression) and decode (decompression) for the PCoIP protocol, which depends on the implementation. Total end-to-end latency is determined by OS latency and …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: July 28, 2023
1371
What does the error message "Session Closed Remotely" mean?
There are a number or reasons that the message "Session Closed Remotely" appears during a brokered session listed below. Informational Messages Closed by login at an alternate location or host shutdown/restart User initiated logout Disconnected by …
Knowledge Base Article Advisory Session HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
1011
How do I choose between remote workstation solutions?
To decide on the most suitable remote workstation solution for your needs, you will need to understand the available options. Remote workstation solutions: Dedicated remote workstation using PCoIP Remote Workstation Cards and PCoIP Zero Clients. See a …
Knowledge Base Article Advisory Performance Setup HP Anyware Remote Workstation Card
Last modified: September 20, 2023
895
What are my options for using PCoIP between trusted and untrusted networks?
PCoIP is encrypted by default and it cannot be disabled. This makes PCoIP itself secure on untrusted networks. To get PCoIP traffic from untrusted networks to PCoIP Hosts the following options can be used: Over a VPN that is UDP compatible. An SSL VPN …
Knowledge Base Article Advisory Security Performance HP Anyware
Last modified: September 3, 2023
735
What network switch or router queue size should be used?
Network device queues, also known as network buffer's, should be configured to accommodate 50ms to 100ms of PCoIP protocol traffic in total. This assumes that one network device (e.g. switch or router) is congested for a given network path. If the network …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 19, 2023
660
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
625
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
610