How does PCoIP handle networks with high traffic volumes?
When you plan to use PCoIP on network with high volumes of other traffic that may cause congestion, it is recommended that QoS is implemented to give PCoIP guaranteed bandwidth. PCoIP will adjust to use it's fair share of the network but UDP is typically …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
219
What is Intelligent Packet Re-Transmission in PCoIP Protocol?
PCoIP Protocol uses UDP protocol similar to other real-time protocols (voice-over-IP, interactive video conferencing etc).  This is done to minimize the overhead associated with TCP protocol.  However, reliable transmission of data is important for remote …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
214
Could the use of two DVI channels be a sources for delay which might cause jitter in a PCoIP Remote Workstation Card configuration?
Using the two DVI channels on a PCoIP Zero Client to PCoIP Remote Workstation Card with the Dual-link DVI connector converter to achieve a 2560x1600 resolution is NOT a source for delay which might cause jitter. The use of two DVI channels could be one of …
Knowledge Base Article Advisory Performance Display Remote Workstation Card Zero Clients
Last modified: July 3, 2020
212
What congestion avoidance should be used in network switches and routers?
Weighted Random Early Discard (WRED) should be configured as the congestion avoidance, or congestion management method. WRED gradually drops packets while considering IP precedence, as network devices become congested. This allows PCoIP protocol …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
201
Is there any bandwidth consumed when a PCoIP device is idle?
The idle bandwidth depends on the PCoIP host type. Below are the idle bandwidths for different host types: HP Anyware 2.12 and newer, the idle bandwidth consumed is 1-2 kbps. VMware View 4.5 (using PCoIP Software 3.5) and earlier, the idle bandwidth …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: August 7, 2023
200
What happens when a PCoIP Packet is lost in transit?
When a PCoIP packet is lost or considered lost, the PCoIP protocol makes an intelligent decision on if the packet should be re-transmitted. PCoIP packets containing audio and sometimes imaging may never be re-transmitted as the next sample of audio or new …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
204
Can I constrain PCoIP bandwidth usage to fit my network?
The maximum PCoIP bandwidth usage an be configured per a session. When restricting the maximum PCoIP session bandwidth, the frame rate and image quality maybe reduced due to the reduction in bandwidth. For limiting PCoIP Zero Clients see: PCoIP Zero …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: August 7, 2023
204
Disable IPv6 in HP Anyware agent
IPv6 is enabled by default in HP Anyware agent starting agent 21.07 release.    Disable IPv6 (Only IPv4 connection is allowed)   Windows agent Open  Registry Editor .  Add registry value under   …
Knowledge Base Article Advisory Setup HP Anyware
Last modified: September 3, 2023
149
Microsoft update to Full Enforcement Mode - impact to PCoIP Zero Client
Microsoft will implement Full Enforcement Mode of Certificate-based authentication changes on Windows domain controllers in February 2025. We have confirmed there will be no impact to PCoIP Zero Client users and smart card authentication will work even …
Knowledge Base Article Advisory Zero Clients Anyware Trusted Endpoints
Last modified: September 25, 2023
134