What are my options for using PCoIP between trusted and untrusted networks?
PCoIP is encrypted by default and it cannot be disabled. This makes PCoIP itself secure on untrusted networks. To get PCoIP traffic from untrusted networks to PCoIP Hosts the following options can be used: Over a VPN that is UDP compatible. An SSL VPN …
Knowledge Base Article Advisory Security Performance HP Anyware
Last modified: September 3, 2023
735
Do PCoIP Zero Clients and PCoIP Remote Workstation Cards support HDMI connections?
PCoIP zero clients only come with the following connections: sVGA DVI (single and dual link) Display Port (1.1a) HDMI is not a supported connector type on PCoIP Zero Clients. You can purchase Display Port or DVI to HDMI cables and adapters however you may …
Knowledge Base Article Advisory Display Setup Remote Workstation Card Zero Clients
Last modified: July 31, 2023
725
What network switch or router queue size should be used?
Network device queues, also known as network buffer's, should be configured to accommodate 50ms to 100ms of PCoIP protocol traffic in total. This assumes that one network device (e.g. switch or router) is congested for a given network path. If the network …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 19, 2023
660
Encryption and bandwidth metrics used for various setups PCoIP Devices and VMware Horizon View
Answer:   Encryption and Bandwidth Metrics   Tera1 Zero Client Tera2 Zero Client Windows View Client Host Card No View Security Server Up to 220 Mbps AES-128 (not encapsulated) Up to 500 Mbps AES-128/AES-256| (not encapsulated/encapsulated) FW 4.1.0 and …
Knowledge Base Article Advisory Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 3, 2023
640
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
625
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
610
Why does my PCoIP Remote Workstation hibernate or sleep and not power off remotely from my Tera 2 PCoIP Zero Client?
When a PCoIP Zero Client attempts to power down a Windows 7 or Windows 10 workstation host during a PCoIP session, the workstation may enter the sleep state rather than being shutdown. This will occur if Windows is configured to map the PC power button to …
Knowledge Base Article Advisory Session Remote Workstation Card Zero Clients
Last modified: July 3, 2020
530
Is it possible to configure the PCoIP Zero Client or PCoIP Remote Workstation Card device name via the hostname option on my DHCP server?
Answer: No you cannot name devices via DHCP, but you can pass your hostname from your PCoIP device to the DHCP server. PCoIP Zero Clients or PCoIP Remote Workstation Cards will pass DHCP options 12 (hostname) and option 15 (domain name) to the DHCP …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 8, 2023
526