What is the DHCP request timeout on a PCoIP Zero Client or PCoIP Remote Workstation Card?
The PCoIP Zero Client and PCoIP Remote Workstation Card will attempt to get a DHCP lease 4 times after power on or after the network link comes up. When a PCoIP device is connected to a network with no DHCP server and the DHCP request time-out period …
Do PCoIP Zero Clients and PCoIP Remote Workstation Cards support HDMI connections?
PCoIP zero clients only come with the following connections: sVGA DVI (single and dual link) Display Port (1.1a) HDMI is not a supported connector type on PCoIP Zero Clients. You can purchase Display Port or DVI to HDMI cables and adapters however you may …
Why does the dual-link DVI monitor connected to my PCoIP Zero Client not display properly?
Check your DVI cable, it may not be dual-link capable. Dual-link cable ends have all of the pins populated whereas single-link cables are missing 6 pins. These pins carry the extra information to allow up to 2560 x 1600 resolution. Some monitors will …
How does competing traffic on the network affect PCoIP performance?
This article outlines how other types of network traffic may negatively impact PCoIP performance. Please refer to  Network session checklist for PCoIP protocol LAN and WAN deployments  for more details on network configuration. On most modern LAN's, …
What network switch or router queue size should be used?
Network device queues, also known as network buffer's, should be configured to accommodate 50ms to 100ms of PCoIP protocol traffic in total. This assumes that one network device (e.g. switch or router) is congested for a given network path. If the network …
How do I improve performance when dragging a window on the screen using firmware pre-4.1.0 and without a PCoIP Hardware Accelerator installed?
Problem While there are many factors that determine desktop performance - see  PCoIP TROUBLESHOOTING STEPS: VMware View Virtual desktop performance  - lower performance of window dragging may be observed in the following environment: VMware Horizon View …
Why do my PCoIP Zero Client image settings have no effect when I change them?
Problem When connecting to your HP Anyware PCoIP Agent or VMware Horizon VM you may notice that the PCoIP Zero Client imaging settings have no effect on the PCoIP Session. The pcoip_server log file and the PCoIP Zero Client AWI both indicate the imaging …
Encryption and bandwidth metrics used for various setups PCoIP Devices and VMware Horizon View
Answer:   Encryption and Bandwidth Metrics   Tera1 Zero Client Tera2 Zero Client Windows View Client Host Card No View Security Server Up to 220 Mbps AES-128 (not encapsulated) Up to 500 Mbps AES-128/AES-256| (not encapsulated/encapsulated) FW 4.1.0 and …
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …