Encryption and bandwidth metrics used for various setups PCoIP Devices and VMware Horizon View
Answer:   Encryption and Bandwidth Metrics   Tera1 Zero Client Tera2 Zero Client Windows View Client Host Card No View Security Server Up to 220 Mbps AES-128 (not encapsulated) Up to 500 Mbps AES-128/AES-256| (not encapsulated/encapsulated) FW 4.1.0 and …
Knowledge Base Article Advisory Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 3, 2023
641
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
626
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
612
ICMP packets are being send from the machine at the start of the PCoIP session
Problem At the start of a PCoIP session a network trace or firewall logs are recording ICMP packet being sent from the machine. Further investigation shows they are from the PCoIP Server process. PCoIP server logs show a trace route log of up to 30 hops. …
Knowledge Base Article Troubleshooting Session Performance HP Anyware
Last modified: September 19, 2023
590
How do I disable login username caching on a PCoIP Zero Client?
On a PCoIP Zero Client, username caching is set in the advanced options and can be disabled from the OSD Screen, the Administrative Web Interface (AWI), or the PCoIP Management Console.    From the OSD Screen: Under Options, select Configuration In the …
Knowledge Base Article Tutorial Setup Management Session Management Console Zero Clients
Last modified: September 3, 2023
593
Configures the PCoIP transport header
Configures the PCoIP transport header with the following options: When set to Enabled , the configured session priority of high , medium , or low is used. When set to Not Configured , then the default of medium session priority is used. When set to …
Knowledge Base Article Tutorial Session HP Anyware
Last modified: September 19, 2023
594
Why can't I get 2560x1600 Resolution on my PCoIP Remote Workstation Access Card (Host Card)?
Answer: Due to display changes after PCoIP Remote Workstation Card Firmware 4.2, you need to disable monitor emulation on all nonactive ports on the PCoIP Remote Workstation Card. Note: Dual port PCoIP Remote Workstation Cards support a maximum of one …
Knowledge Base Article Troubleshooting Display Remote Workstation Card
Last modified: November 18, 2022
577
Why does my PCoIP Remote Workstation hibernate or sleep and not power off remotely from my Tera 2 PCoIP Zero Client?
When a PCoIP Zero Client attempts to power down a Windows 7 or Windows 10 workstation host during a PCoIP session, the workstation may enter the sleep state rather than being shutdown. This will occur if Windows is configured to map the PC power button to …
Knowledge Base Article Advisory Session Remote Workstation Card Zero Clients
Last modified: July 3, 2020
531