Tera 1 PCoIP Zero Client or PCoIP Remote Workstation card firmware prerequisites when upgrading to new firmware releases.

Rate this Article
Average: 1 (1 vote)

September 10, 2018

Last modified: 09/03/2023, 6:14 pm

Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients

Answer:

Note: HP Anyware Tera 1 PCoIP Zero Client devices and firmware are End of Life. Whist Tera 1 based PCoIP Zero Clients can be upgraded to Firmware 4.7.1 they lack many of the modern security standards for network communication. It is recommended that Tera 2 based PCoIP Zero Clients replace any Tera 1 based PCoIP Zero Clients. End-of-Life Details: Tera1 Firmware

Depending on the currently installed firmware version on your Tera 1 device, an upgrade to new firmware may require an intermediate firmware upload.

To upgrade the PCoIP zero client and PCoIP host card firmware, follow the associated upgrade installations steps for the currently installed firmware.

Currently Installed Firmware      

   Upgrade Installation Steps   

4.5.0 through 4.7.1
  1. Install newer firmware.
    PCoIP Zero Clients
    Current PCoIP Products and Releases

1.4 through 4.2.0
  1. Install a 4.5.x, or 4.6.x firmware release.    
  2. Install newer firmware when available.
    PCoIP Zero Clients

0.18 through 1.3
  1. Install a 1.x firmware release (1.4 or later).
  2. Install a 4.5.x or 4.6.0 firmware release.
  3. Install newer firmware when available.
    PCoIP Zero Clients

0.1 through 0.17
  1. Install Legacy firmware Release 0.18.
  2. Install a 1.x firmware release (1.4 or later).
  3. Install a 4.5.x or 4.6.0 firmware release.
  4. Install newer firmware when available.
    PCoIP Zero Clients

Note: The firmware version can be viewed on the Info > Version web page for the device.

See Also: