How to configure a PCoIP Zero Client to auto-connect to a Remote Workstation Card

Rate this Article
No votes yet

August 1, 2018

Last modified: 09/14/2023, 6:06 am

Knowledge Base Article Tutorial Setup Remote Workstation Card Zero Clients
Answer:

To enable auto connect, you need to peer the PCoIP Zero Client to the Remote Workstation Card. You will need the IP and MAC of the host. You enter this in the PCoIP Zero Client's configuration (On Screen Display or Administrative Web Interface), under Configuration > Session, and drill into the Advanced options. Then enable Auto-Connect.

For more information, refer to the PCoIP Zero Client and Host Administration Guide (search for key phrase "Auto Connect") in the Administrators' guide.

 

Pertains to:
  • Remote Workstation Card 4.0.2
  • Remote Workstation Card 4.0.3
  • Remote Workstation Card 4.1.0
  • Remote Workstation Card 4.1.1
  • Remote Workstation Card 4.1.2
  • Remote Workstation Card 4.2.0
  • Remote Workstation Card 4.5.0
  • Remote Workstation Card 4.5.1
  • Remote Workstation Card 4.6.0
  • Remote Workstation Card 4.7.0
  • Remote Workstation Card 4.7.1
  • Remote Workstation Card 4.7.2
  • Remote Workstation Card 4.7.4
  • Remote Workstation Card 4.7.5
  • Remote Workstation Card 4.9.0
  • PCoIP Zero Client 4.0.2
  • PCoIP Zero Client 4.0.3
  • PCoIP Zero Client 4.1.0
  • PCoIP Zero Client 4.1.1
  • PCoIP Zero Client 4.1.2
  • PCoIP Zero Client 4.2.0
  • PCoIP Zero Client 4.5.0
  • PCoIP Zero Client 4.5.1
  • PCoIP Zero Client 4.6.0
  • PCoIP Zero Client 4.7.0
  • PCoIP Zero Client 4.7.1
  • PCoIP Zero Client 4.8.0
  • PCoIP Zero Client 4.8.1
  • PCoIP Zero Client 4.8.2
  • PCoIP Zero Client 5.0.0
  • PCoIP Zero Client 5.0.2
  • PCoIP Zero Client 5.1.0
  • PCoIP Zero Client 5.1.1
  • PCoIP Zero Client 5.2.0
  • PCoIP Zero Client 5.2.1
  • PCoIP Zero Client 5.2.2
  • PCoIP Zero Client 5.3.0
  • PCoIP Zero Client 5.4.0
  • PCoIP Zero Client 5.4.1
  • PCoIP Zero Client 5.5.0
  • PCoIP Zero Client 5.5.1
  • PCoIP Zero Client 6.0.0