Why do I get poor performance on an MPLS network?
There are a number of configuration requirements for using PCoIP protocol on an MPLS network.  Prioritize PCoIP packets as a best practice Avoid packet loss Avoid out-of-order packets PCoIP protocol may consider out-of-order packets as lost if the data …
Knowledge Base Article Troubleshooting Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
312
How do I ensure a fair allocation of bandwidth between multiple PCoIP sessions?
The PCoIP congestion avoidance algorithms are designed to ensure a fair allocation of bandwidth between multiple PCoIP sessions on the same network. There may be some networks where this doesn't work as well. There is also an associated time constant for …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card
Last modified: December 9, 2022
306
How does PCoIP share bandwidth over the network?
The BW Limit is dynamically calculated and represents the bandwidth the PCoIP session estimates to be available given the network conditions. The calculation takes into account the existing bandwidth usage, packet loss and any high latency spikes. The …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
296
How can I tell if the 802.1x certificate uploaded successfully?
A good test is to use the web UI to upload the 802.1x certificate. From the web UI, go to Upload> Certificate and view the screen. If the certificate is listed after a restart of the PCoIP Zero Client then the certificate was uploaded successfully (see …
Knowledge Base Article Tutorial Security Remote Workstation Card Zero Clients
Last modified: August 23, 2018
282
Does the Phillips Digital Pocket Memo work with a PCoIP Zero Client and VMware Horizon View?
Scenario A Philips Digital Pocket Memo (DPM) device does not operate after connecting to a PCoIP Zero Client using the USB EHCI controller (USB 2.0). Occasionally the PCoIP Zero Client unexpectedly restarts.   Cause The Philips Digital Pocket Memo device …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: October 31, 2022
280
No warning message when VMware View Connection Server Certificate Check Mode is set to Warn if Connection may be insecure (Default)
This is expected behavior. Configured non-interactive session modes do not display VCS Warning messages in Warn if the connection may be insecure (Default) security mode.  Interactive session modes will display VCS Error messages in Warn if the connection …
Knowledge Base Article Troubleshooting Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
281
Does PCoIP Protocol support half duplex networking equipment?
PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients
Last modified: July 3, 2020
273