Why does the dual-link DVI monitor connected to my PCoIP Zero Client not display properly?
Check your DVI cable, it may not be dual-link capable. Dual-link cable ends have all of the pins populated whereas single-link cables are missing 6 pins. These pins carry the extra information to allow up to 2560 x 1600 resolution. Some monitors will …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 22, 2022
714
What are the possible reasons for jitter on a 30 inch monitor when compared to a 24 inch monitor connected to the same Tera2 Remote Workstation Card?
Problem In a single workstation environment when comparing a 30 inch monitor at 2560x1600 to a 24 inch monitor at 1920x1600, moving a window containing a running video in the 30 inch screen shows latency and window drag when compared to the 24 inch …
Knowledge Base Article Troubleshooting Display Performance Remote Workstation Card
Last modified: December 9, 2022
693
Upgrading from firmware 3.4.x or earlier, a message displays indicating my USB devices failed authorization
Problem When upgrading PCoIP Zero Client firmware from 3.4.x, USB locally terminated devices work, but no redirected (bridged) USB devices work. When viewing attached devices in the Administrator Web Interface (AWI) only the mouse and keyboard show as …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: September 25, 2023
689
Why do my PCoIP Zero Client image settings have no effect when I change them?
Problem When connecting to your HP Anyware PCoIP Agent or VMware Horizon VM you may notice that the PCoIP Zero Client imaging settings have no effect on the PCoIP Session. The pcoip_server log file and the PCoIP Zero Client AWI both indicate the imaging …
Knowledge Base Article Troubleshooting Session Display Zero Clients
Last modified: September 7, 2023
646
Why do USB 2.0 or isochronous devices fail to work as expected when plugged into a Samsung NC220 or NC240 PCoIP monitor?
Answer: This occurs because on the NC220 and NC240 monitor series, USB Ports 0, 1 and 2 are brought out directly and port 3 is connected to an internal hub. On this hub, 1 hub port is connected to a RS232 device, and another hub port is connected to an …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: November 21, 2022
637
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
628
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
613
How do I update the HP Anyware registration code in HP Anyware Manager?
This article illustrates how to update the HP Anyware registration code in HP Anyware Manager. The steps in this article are for Microsoft Azure only.   Requirements HP Anyware Manager has been deployed, up and running. Admin access to HP Anyware Manager …
Knowledge Base Article Tutorial Licensing Management HP Anyware
Last modified: September 3, 2023
607