How does PCoIP share bandwidth over the network?
The BW Limit is dynamically calculated and represents the bandwidth the PCoIP session estimates to be available given the network conditions. The calculation takes into account the existing bandwidth usage, packet loss and any high latency spikes. The …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
296
How long before a PCoIP Management Console certificate expires should I replace it?
Before the PCoIP Management Console certificate can be replaced, the new certificate or the signing root CA certificate must be installed in the PCoIP Zero Client or PCoIP Remote Workstation Card certificate store. Once a PCoIP Endpoint is manged by an …
Knowledge Base Article Advisory Management Security Management Console
Last modified: September 19, 2023
295
CVE-2019-5544 - Security Notice: Information regarding recently discovered OpenSLP vulenerability
  HP Anyware uses OpenSLP library which has been reported affected by CVE-2019-5544. HP Anyware does not believe the vulnerability is exploitable on either the Zero Client or  Remote Workstation Card but as an absolute guarantee customers may want …
Knowledge Base Article Advisory Security Management Console Remote Workstation Card Zero Clients
Last modified: August 7, 2023
295
Error: PCoIP Agent has no available licenses to launch the remote session
Symptom Remote desktops that were previously registered with HP Anyware Cloud License Server (CLS) may get the following client message when trying to connect: “Error – PCoIP Agent has no available licenses to launch the remote session.” In the Anyware …
Knowledge Base Article Advisory Troubleshooting Licensing HP Anyware
Last modified: September 3, 2023
299
What are the limitations of configuring active directory with Management Console?
PCoIP Management Console 3.2.x has important limitations which need to be considered before using this feature in your deployment.   Active Directory users must be assigned to a Security Group. Only supports one active domain at a time. Does not support …
Knowledge Base Article Advisory Setup Management Console
Last modified: April 10, 2019
279
Does PCoIP Protocol support half duplex networking equipment?
PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients
Last modified: July 3, 2020
273
How do I change the FQDN (Fully Qualified Domain Name) of a PCoIP Zero Client?
First, change the PCoIP name to a new name. Currently, the "PCoIP Device Name" can only be changed on an individual basis in two locations: The  "OSD--> Configuration--> Label"  tab The  "AWI--> Configuration--> Label"  tab The default format is  …
Knowledge Base Article Advisory Management Management Console Zero Clients
Last modified: September 3, 2023
254