The incorrect workstation powers on when trying to connect to a PCoIP Remote Workstation Card from a PCoIP Zero Client
Problem You might encounter the following problem if you use a PCoIP Zero Client to switch between workstations, i.e. computers with a PCoIP Remote Workstation Card (host card) installed: the first workstation wakes up and connects normally, but the …
Knowledge Base Article Troubleshooting Remote Workstation Card Zero Clients
Last modified: September 19, 2023
281
What are the limitations of configuring active directory with Management Console?
PCoIP Management Console 3.2.x has important limitations which need to be considered before using this feature in your deployment.   Active Directory users must be assigned to a Security Group. Only supports one active domain at a time. Does not support …
Knowledge Base Article Advisory Setup Management Console
Last modified: April 10, 2019
279
How can I tell if the 802.1x certificate uploaded successfully?
A good test is to use the web UI to upload the 802.1x certificate. From the web UI, go to Upload> Certificate and view the screen. If the certificate is listed after a restart of the PCoIP Zero Client then the certificate was uploaded successfully (see …
Knowledge Base Article Tutorial Security Remote Workstation Card Zero Clients
Last modified: August 23, 2018
278
Why Imported Profile(s) from PCoIP Management Console 1.x/2.x to PCoIP Management Console 3.x cannot be applied? Status shows skipped.
Scenario Imported a profile from PCoIP Management Console 1.x /2.x  to PCoIP Management Console 3.x where firmware 6.0.0 is the only uploaded version in Settings -> Software. Pushing the profile to PCoIP Zero Clients results in a 'skipped' status.   Cause …
Knowledge Base Article Troubleshooting Management Management Console
Last modified: September 19, 2023
276
Does PCoIP Protocol support half duplex networking equipment?
PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients
Last modified: July 3, 2020
273
How do I configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card?
There are three ways to configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card. Option 1: Use the PC NIC and PCoIP Host Software  For instructions, refer to How do I remotely power on the host PC/workstation through its network interface …
Knowledge Base Article Tutorial Setup Remote Workstation Card
Last modified: August 23, 2018
265
Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Knowledge Base Article Troubleshooting Setup Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 20, 2023
265