Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

Why do I hear pops and crackles or dead air in my PCoIP session when connecting with a PCoIP Zero Client?

This article refers to the audio playback using the PCoIP Analog Audio Data Channel from a host machine to a PCoIP Zero Client. It does not apply to microphone input from a PCoIP Zero Client to a VM. Problem The PCoIP Zero Client must have either an …

How do I enable relative mouse option in PCoIP Zero Clients?

The relative mouse option was introduced in Tera2 PCoIP Zero Client firmware 4.1 as an unsupported option for use in very specific user requirements (3D gaming and CAD) and demonstration environments. This option is hidden and disabled by default in …

Configuring PCoIP Zero Client for webcam support

When using a PCoIP zero client to connect to a software host such as HP Anyware Agent or VMware Horizon Agent, you need to ensure USB redirection is enabled when installing the host agent. With USB redirection installed we can now troubleshoot from the …

How to tune PCoIP for bandwidth constrained Network?

Bandwidth Tuning To determine if bandwidth tuning is required, setup a PCoIP session and monitor the performance of your system. The values to record are latency, latency variation, packet loss and tx and rx statistics. For details on how to run these …

How much bandwidth does PCoIP require?

The simple answer is 'it depends'. The amount of bandwidth required depends on a number of factors (display resolution, frame rate, graphical intensity for the user, importance of image quality, amount of display interactivity vs static viewing). Due to …

Poor audio lip sync with HP Anyware

Problem When watching video or performing any activity that requires audio sync, the audio is out of sync. This results in loss of lip sync where the spoken audio does not match the mouth movements in the video. This occurs on the Teradici Software Client …

Is it possible to disable the serial port on my Samsung PCoIP Zero Client monitor?

Scenario: Some PCoIP zero clients (i.e. Samsung PCoIP Zero Client monitors) come equipped with a serial port. The units are designed with a built in USB hub feeding both another USB connector and a serial connector. In a PCoIP session, the VM picks up the …

What does the error message "Session Closed Remotely" mean?

There are a number or reasons that the message "Session Closed Remotely" appears during a brokered session listed below. Informational Messages Closed by login at an alternate location or host shutdown/restart User initiated logout Disconnected by …

How do I change the image quality properties of a PCoIP Remote Workstation Card?

Review the below table to understand where to change the image quality properties in a remote workstation environment. This information applies to sessions between PCoIP Zero Clients and a PCoIP Remote Workstation Card (i.e. host card). If you are using a …

How many VMware View pools are supported by PCoIP Zero Clients?

PCoIP Zero Clients support up to 10 desktop pools when using Firmware 3.2.0 or earlier. Firmware 3.3.0 and later increased support for the number of pools to 100. When more than 100 pools are configured, the PCoIP Zero Client becomes unresponsive for a …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics