Why can a session not be establish after a user disconnects while the Windows "waiting for programs to close" dialog is showing?
Problem When disconnecting a PCoIP session while Windows is shutting down or a user account is logging off with the "waiting for programs to close" dialog is showing; the ability to reconnect the PCoIP session is lost.    Cause When Windows is shutting …
Knowledge Base Article Troubleshooting Session HP Anyware
Last modified: November 17, 2022
232
Error Failed to find anything in domain DN when installing HP Anyware Connector
ERROR Failed to find anything in domain DN   Issue: When trying to install HP Anyware Connector you receive the error "ERROR Failed to find anything in domain DN: dc=172,dc=31,dc=18,dc=194" (note that the ip in the error will not be the same). The most …
Knowledge Base Article Troubleshooting Management HP Anyware
Last modified: September 3, 2023
225
Local Administrative Password setting is disabled after changing the firmware version in the profile in the PCoIP Management Console 3.0.0
Problem After changing the firmware version in a profile in PCoIP Management Console 3.0.0 the Local Administrative Password setting is no longer enabled and the password field is blank.   Cause This issue is known to happen when the following conditions …
Knowledge Base Article Troubleshooting Security Management Management Console
Last modified: November 7, 2022
223
Recovering the OSD when the resolution was set to 800x600 or lower which removed functionality.
This occurs because these low resolutions do not display the OSD correctly, and access to some configurations are lost. Previously this was not an available feature which prevented devices being put into un-configurable states by setting resolutions to …
Knowledge Base Article Troubleshooting Display Management Console Zero Clients
Last modified: September 3, 2023
221
Could the use of two DVI channels be a sources for delay which might cause jitter in a PCoIP Remote Workstation Card configuration?
Using the two DVI channels on a PCoIP Zero Client to PCoIP Remote Workstation Card with the Dual-link DVI connector converter to achieve a 2560x1600 resolution is NOT a source for delay which might cause jitter. The use of two DVI channels could be one of …
Knowledge Base Article Advisory Performance Display Remote Workstation Card Zero Clients
Last modified: July 3, 2020
212
Why is the image quality reduced for a couple seconds right after a session is connected?
This is expected behaviour during the first couple seconds when a PCoIP session is established and is caused by the PCoIP device's bandwidth management algorithm. The algorithm continuously optimizes the amount of network traffic a PCoIP device generates …
Knowledge Base Article Troubleshooting Session Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 7, 2023
199
What does GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout mean in the log?
Problem Message GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout is found in host or client log file.   Cause GSOAP is the protocol used by the PCoIP Management Console 1.x. This error is caused by a socket being opened by GSOAP and not closed …
Knowledge Base Article Troubleshooting Management Management Console Remote Workstation Card Zero Clients
Last modified: September 8, 2023
195