What does the 'No source signal' message mean?
The answer depends on what type of host the PCoIP Zero Client is connected to.  VMware View 4.5 or newer The message "no source signal" appears as an overlay when the VMware View virtual desktop puts the monitors to sleep.  Pressing a key or moving the …
Knowledge Base Article Troubleshooting Display HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3654
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3608
Is Network Quality of Service - QoS Required for PCoIP protocol deployments?
Since PCoIP is a real-time protocol, quality of service (QoS) must be implemented for virtual desktop or remote workstation deployments using the PCoIP protocol in constrained environments. Teradici previously recommended QoS as essential for successful …
Knowledge Base Article Advisory HP Anyware Remote Workstation Card Zero Clients
Last modified: February 6, 2024
3405
How do I Set Zero Client password in PCoIP Management Console?
Use PCoIP Management Console PCoIP Management Console is recommended to manage the password setup for zero clients, including enabling the password protection for OSD and AWI, setting the password, and whether or not hiding the Password options from OSD …
Knowledge Base Article Tutorial Authentication Management Management Console Zero Clients
Last modified: September 3, 2023
3141
Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3107
How do I remotely power on the host PC/workstation through its network interface (PC NIC) from a PCoIP Zero Client?
Answer: Follow the steps below to set up the host PC NIC for Wake-on-LAN (WOL) feature, to allow a workstation with a PCoIP Remote Workstation Card (host card) installed to be woken up by a PCoIP Zero Client. You can also remotely power on your …
Knowledge Base Article Tutorial Remote Workstation Card Zero Clients
Last modified: September 14, 2023
2910