Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

Does the PCoIP Management Console 2.x and 3.x ship with a default certificate?

Yes. The PCoIP Management Console since release 2.x ships with a HP Anyware self-signed certificate to allow the PCoIP Management Console to function out of the box. It is recommended that all users deploying the PCoIP Management Console 2.x or …

Does the TERA2321 support the SGMII interface for a copper SFP?

Answer: No. The Tera2321 only supports MII (10/100Mbps) or RGMII (10/100/1000Mbps) copper/fiber interfaces. Definitions : SGMII - Serial Gigabit Media Independent Interface. RGMII - Reduced Gigabit Media Independent Interface. MII - Media Independent …

Can I add software to or change the operating system of a PCoIP Zero Client?

PCoIP Zero Clients do not run local application software. They run secure custom firmware created by HP Anyware only. This makes them extremely secure PCoIP Clients allowing for simple management and updates through small firmware updates. New features …

Knowledge Base Article Tutorial Setup Zero Clients

Last modified: September 22, 2023

239

Random individual and mass client disconnects due to Cisco VSS Inter-switch links

Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops. Cause There have been observed …

What are the priorities for video, audio, and USB PCoIP traffic?

PCoIP technology gives priority to USB and audio, while imaging uses remaining available bandwidth. PCoIP technology optimizes user experience for a given bandwidth by adaptively controlling quality and update rate of the image data, and optionally …

Can virtual channels cause issues with a PCoIP session?

Usually this is not an issue. However, if a virtual channel created by a third party is not properly created, it can cause unpredictable results with a PCoIP session or the displayed output. This should be considered as a possible source of an identified …

How do I make PCoIP Remote Workstation Card USB devices work on my Fujitsu CELSIUS R930 workstation?

Answer: If USB devices won't work on a R930, move the PCoIP Remote Workstation Card to a PCIe slot that is serviced by a populated CPU socket. Why this is necessary: The R930 has two sockets. If the unit ships with only one socket populated (a single …

How does PCoIP handle networks with high traffic volumes?

When you plan to use PCoIP on network with high volumes of other traffic that may cause congestion, it is recommended that QoS is implemented to give PCoIP guaranteed bandwidth. PCoIP will adjust to use it's fair share of the network but UDP is typically …

Can I share the network connection of the PCoIP Remote Workstation Card with that of the host PC/workstation?

No, the network interface on the PCoIP Remote Workstation Card is independent to that of the host. It is not possible to communicate to the host operating system via the PCoIP Remote Workstation Card network interface. Therefore, you must connect both the …

What is Intelligent Packet Re-Transmission in PCoIP Protocol?

PCoIP Protocol uses UDP protocol similar to other real-time protocols (voice-over-IP, interactive video conferencing etc). This is done to minimize the overhead associated with TCP protocol. However, reliable transmission of data is important for remote …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics