In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
PCoIP Software session variables provide an easy and flexible way for administrators to tune and configure a PCoIP session if required. HP Anyware PCoIP Agent There are two PCoIP group policy object template files in PCoIP Agent version 2.11 onwards. …
Problem The monitor attached to the PCoIP Zero Client is using a resolution much lower than expected. The attached devices on the AWI \u2192 Info \u2192 Attached devices show EDID read failure. The Display Topology section in the zero client log file …
Answer: 2560x1440 and 2560x1600 resolutions share the same cable requirements. Review and follow the instructions for connectors and cables in Dual-link DVI, Single-link DVI, DisplayPort and 2560x1600 resolutions with PCoIP products. . To get a 2560x1440 …
Note: This knowledge base article does not apply to HP Anyware. HP Anyware uses a Anyware software GPU or a hardware GPU disabling the vSphere Console. In some cases viewing a remote users PCoIP session may be beneficial to troubleshooting an issue. In …
Use PCoIP Management Console PCoIP Management Console is recommended to manage the password setup for zero clients, including enabling the password protection for OSD and AWI, setting the password, and whether or not hiding the Password options from OSD …
This message indicates that an unauthorized USB device is attached to the PCoIP Zero Client. Be sure allowed USB devices are specified in the list of authorized devices and not in the list of unauthorized devices in the USB page of the PCoIP Zero Client's …
Prerequisites eToken devices work based on the scenario in which they are intended to be used and the proper installation of the PCoIP Smartcard feature. Three scenario's are described below after the PCoIP Smartcard installation: PCoIP Smartcard …
Answer: To resolve this issue, please make sure that you have the following installed and set correctly on the host PC/workstation - i.e. a computer with a PCoIP Remote Workstation Card (host card) installed: The host card should be running PCoIP firmware …