Profile application to Remote Workstation Card fails
Scenario : The remote workstation card is at a factory default. You set a basic Profile in the management console and apply the Profile. The Profile application fails. If you check the management console, there is no clue as to why the Profile failed. If …
What does "MCU not initialized" log message mean?
Problem You are unable to manage a zero client using the HP Anyware PCoIP Management Console 1.x (MC). The event logs reveal the following MCU errors: LVL:1 RC:-500        MCU :(tera_mcu_read_eeprom_bit): Cannot read from EEPROM, MCU not initialized. …
How can I tell which monitors are connected and if a USB device is connected locally or bridged on a PCoIP Zero Client?
Answer: From your Web browser, enter the IP address of your PCoIP Zero Client. Log in to the user interface with your user credentials. (Note: Depending on your specific setup, a password may not be required.) From the Info menu, select Attached Devices . …
How do I change the FQDN (Fully Qualified Domain Name) of a PCoIP Zero Client?
First, change the PCoIP name to a new name. Currently, the "PCoIP Device Name" can only be changed on an individual basis in two locations: The  "OSD--> Configuration--> Label"  tab The  "AWI--> Configuration--> Label"  tab The default format is  …
Why do certain large screen (>27" monitors) dual-link DVI monitors not work with the TERA 2 PCoIP Zero Clients?
Scenario When some monitors supporting 2560 x 1600 and 2560 x 1440 resolutions are power cycled with the power switch, the video may not appear when connected to a Tera2 Zero Client via dual-link DVI. This applies to: Tera2 Zero Clients running firmware …
Management Console profile is not applied to the Remote Workstation Card
Applying a Profile to a Remote Workstation Card from PCoIP Management Console will be unsuccessful if the Enable Audio setting on the Remote Workstation Card has never been enabled (default is disabled) or the Remote Workstation Card has not had the …
Recovering the OSD when the resolution was set to 800x600 or lower which removed functionality.
This occurs because these low resolutions do not display the OSD correctly, and access to some configurations are lost. Previously this was not an available feature which prevented devices being put into un-configurable states by setting resolutions to …
Could the use of two DVI channels be a sources for delay which might cause jitter in a PCoIP Remote Workstation Card configuration?
Using the two DVI channels on a PCoIP Zero Client to PCoIP Remote Workstation Card with the Dual-link DVI connector converter to achieve a 2560x1600 resolution is NOT a source for delay which might cause jitter. The use of two DVI channels could be one of …
What does GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout mean in the log?
Problem Message GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout is found in host or client log file.   Cause GSOAP is the protocol used by the PCoIP Management Console 1.x. This error is caused by a socket being opened by GSOAP and not closed …