Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?

In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …

Tuning PCoIP for high performance workloads

This articles provides 4 reference workloads that demonstrate how PCoIP can be optimized Table of Contents: Tuning options for Workloads of various types Office workloads 3D Rendering workloads High Fidelity workloads Video Playback workloads …

Error: The Certificate for the Domain Controller is Untrusted or Invalid

Problem When connecting to a HP Anyware PCoIP Agent the client receives the error "The Certificate for the Domain Controller is Untrusted or Invalid." Causes: The error generally means that the HP Anyware Connector was unable to communicate with …

Is Network Quality of Service - QoS Required for PCoIP protocol deployments?

Since PCoIP is a real-time protocol, quality of service (QoS) must be implemented for virtual desktop or remote workstation deployments using the PCoIP protocol in constrained environments. Teradici previously recommended QoS as essential for successful …

How do I set up or override PCoIP Software Session Variables?

PCoIP Software session variables provide an easy and flexible way for administrators to tune and configure a PCoIP session if required. HP Anyware PCoIP Agent There are two PCoIP group policy object template files in PCoIP Agent version 2.11 onwards. …

Why does an EDID read failure cause my display attached to the PCoIP Zero Client to using a lower resolution than expected.

Problem The monitor attached to the PCoIP Zero Client is using a resolution much lower than expected. The attached devices on the AWI \u2192 Info \u2192 Attached devices show EDID read failure. The Display Topology section in the zero client log file …

PCoIP Agent reported "This version of trusted storage is not supported"

Problem The PCoIP Agent stops immediately after starting, and the log file contains: " Failed to add FNE trial license source: [1,7E1,2,0[70000027,0,5002E]] This version of trusted storage is not supported" Or running the pcoip-validate-license.ps1 …

Is PCoIP compatible with a VPN?

PCoIP Traffic can be used with a UDP-compatible VPN but tunneling PCoIP through a TCP VPN such as ZScaler ZPA is unsupported. Consult VPN Guidelines in the HP Anyware Session Planning Guide for VPN alternatives and additional information. Note: Some VPN's …

PCoIP Agent has no available licenses to launch the remote session. Please try again later. If this failure persists, please report this failure to your system administrator.

Problem When starting a PCoIP session, the PCoIP Client shows the message "PCoIP Agent has no available licenses to launch the remote session. Please try again later. If this failure persists, please report this failure to your system administrator." …

How do I set my monitor resolution to 2560x1440 with PCoIP products?

Answer: 2560x1440 and 2560x1600 resolutions share the same cable requirements. Review and follow the instructions for connectors and cables in Dual-link DVI, Single-link DVI, DisplayPort and 2560x1600 resolutions with PCoIP products. . To get a 2560x1440 …

Knowledge Base Article Advisory Display Zero Clients

Last modified: September 3, 2023

3271

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics