Why can't I change the display resolution in Windows when using HP Anyware on Windows?
Problem When connected to a remote machine via HP Anyware on Windows, opening the display settings results in greyed out options and a message "Some settings are controlled by your system administrator". You cannot change the screen resolution, select the …
Knowledge Base Article Troubleshooting Display HP Anyware Zero Clients
Last modified: April 16, 2024
11577
The impact of graphics card temporal dithering
Temporal dithering is an intentionally applied blurring method used by some graphics cards to increase the amount of color and shading that can be done on a system. It's a trade-off between a little distortion and much smoother looking pictures. During …
Knowledge Base Article Advisory Performance Display Remote Workstation Card Zero Clients
Last modified: February 27, 2024
8984
Why has my PCoIP Client display temporarily shown a black screen?
Scenario While in a PCoIP session, the display(s) temporarily go black for a few seconds (typically 1-5 seconds) and then resumes normal operation. Occasionally the screen may be briefly frozen instead of turning black.   Cause This entry signifies that …
Knowledge Base Article Troubleshooting Performance Display HP Anyware Zero Clients
Last modified: September 13, 2023
8164
Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4874
Using a custom display resolution and the Hot Plug Reset function on a PCoIP Zero Client
Setting a custom display resolution A PCoIP Zero Client allows you to set a custom display resolution on the client, which is saved even when the client is powered down. This lets you set a resolution that is different than the attached display's native …
Knowledge Base Article Tutorial Setup Display Zero Clients
Last modified: September 3, 2023
4079
PCoIP display is 'blurry' and the image is of lower than expected quality
Problem When using PCoIP the display is 'blurry' or of low quality. The display may be persistently blurry or is blurry intermittently and slow.    Cause Typically a blurry screen is due to the lack of bandwidth. Throughout a PCoIP session, PCoIP network …
Knowledge Base Article Troubleshooting Performance Display Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
3789
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3513
What does the 'No source signal' message mean?
The answer depends on what type of host the PCoIP Zero Client is connected to.  VMware View 4.5 or newer The message "no source signal" appears as an overlay when the VMware View virtual desktop puts the monitors to sleep.  Pressing a key or moving the …
Knowledge Base Article Troubleshooting Display HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3505
Why does an EDID read failure cause my display attached to the PCoIP Zero Client to using a lower resolution than expected.
Problem The monitor attached to the PCoIP Zero Client is using a resolution much lower than expected.  The attached devices on the AWI \u2192 Info \u2192 Attached devices show EDID read failure. The Display Topology section in the zero client log file …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: September 3, 2023
3270