What are the network maximum transmission unit (MTU) requirements for PCoIP?
PCoIP maximum transmission unit (MTU) Requirements Every network has a MTU that dictates the maximum size a individual network packet can be for transmission. If the packet is larger than the MTU it will be fragmented and sent as multiple packets or …
Knowledge Base Article Tutorial Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
6776
How do I check for packet loss on the ESX interface?
If there is packet loss on a PCoIP protocol session, but an analysis of network devices in the path show no loss and they have been properly configured (see  Network session checklist for PCoIP protocol LAN and WAN deployments ) then you may want to …
Knowledge Base Article Tutorial Performance Third Party Enhancements Remote Workstation Card
Last modified: September 3, 2023
5517
Using HP Anyware PCoIP Zero Clients and Remote Workstation Cards on a direct-connect (no IP) network
Direct-connect (no IP network) configurations, sometimes incorrectly referred to as "home-run networks", refer to a direct connection between 2 devices without network switches/hubs installed using straight through cables via patch-panels. Although zero …
Knowledge Base Article Tutorial Performance Setup Remote Workstation Card Zero Clients
Last modified: September 14, 2023
5174
How can I determine the frame rate at a PCoIP protocol client?
Answer: There are a multiple ways to determine the frame update rate displayed at the PCoIP Zero Client.    Note: the frame rate displayed at the client this may be different than the source display frame rate when in a congested network environment.  Log …
Knowledge Base Article Tutorial Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
1482
How do I optimize the Windows 7 desktop experience settings to reduce PCoIP session bandwidth?
Answer: On a Microsoft Windows 7 machine, make the following change to the Windows optimization settings: Start > Computer > System Properties > Advanced System Properties > Performance Settings button > Adjust for best performance . Alternatively, you …
Knowledge Base Article Tutorial Performance HP Anyware Zero Clients
Last modified: September 20, 2023
1468
How do I change the image quality properties of a PCoIP Remote Workstation Card?
Review the below table to understand where to change the image quality properties in a remote workstation environment. This information applies to sessions between PCoIP Zero Clients and a PCoIP Remote Workstation Card (i.e. host card). If you are using a …
Knowledge Base Article Tutorial Performance Display Setup Zero Clients
Last modified: July 31, 2023
926
How to configure audio in a Linux workstation with a Tera1 or Tera2 Remote Workstation Card
Note: This knowledge base article covers older versions of Linux, newer modern versions Linux will automatically pick up the Audio device on the PCoIP Remote Workstation Card and activate the audio drivers. This knowledge base article has been made …
Knowledge Base Article Tutorial Performance Remote Workstation Card
Last modified: November 18, 2022
907