Can a PCoIP Remote Workstation Card be brokered by VMware Horizon View?
A PCoIP Remote Workstation Card (host card) can be brokered by VMware View 4.5 and newer. This way, the host can be accessed by either a PCoIP Zero Client or the VMware View software client. Refer to  PCoIP Remote Workstation Card 4.9.0 Administrators' …
What does the error message "Session Closed Remotely" mean?
There are a number or reasons that the message "Session Closed Remotely" appears during a brokered session listed below. Informational Messages Closed by login at an alternate location or host shutdown/restart User initiated logout Disconnected by …
Are there any limitations on physical distance for a PCoIP session?
Due to the design of PCoIP, using UDP for data transmission, PCoIP will operate over vast distances and network latencies up to 250 ms. PCoIP intelligently acknowledges the traffic inside the protocol allowing for high speed transmission over high latency …
How do I configure a Peer-to-Peer Connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card?
Requirements This article describes the configuration of a peer-to-peer, or dedicated connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card including dual and quad display scenario's. Single or dual display requires a single PCoIP …
Encryption and bandwidth metrics used for various setups PCoIP Devices and VMware Horizon View
Answer:   Encryption and Bandwidth Metrics   Tera1 Zero Client Tera2 Zero Client Windows View Client Host Card No View Security Server Up to 220 Mbps AES-128 (not encapsulated) Up to 500 Mbps AES-128/AES-256| (not encapsulated/encapsulated) FW 4.1.0 and …
Connecting a new PCoIP Zero Client to an existing PCoIP Remote Workstation Card.
In general, newer firmware in PCoIP Remote Workstation Cards (host cards) are backward compatible with PCoIP Zero Clients using older firmware. However, enhancements to firmware may produce unexpected behaviors. Important changes are documented in each …
Why does my PCoIP Remote Workstation hibernate or sleep and not power off remotely from my Tera 2 PCoIP Zero Client?
When a PCoIP Zero Client attempts to power down a Windows 7 or Windows 10 workstation host during a PCoIP session, the workstation may enter the sleep state rather than being shutdown. This will occur if Windows is configured to map the PC power button to …
PCoIP Host Driver Software 4.3.1 does not automatically map the PCoIP remote workstation cards in Leostream.
Answer : If you try to automatically map the PCoIP remote workstation card (host card) running PCoIP Host Driver Software 4.3.1 and using the Leostream broker it will fail. If you downgrade the PCoIP Host Driver Software to 4.2.2 it automatically maps. …