Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

What does "No Available Hosts for Connection" mean?

The message "No Available Hosts for Connection" appears if the PCoIP Zero Client has enabled the Host Discovery feature and tries to establish a session but cannot find a PCoIP Remote Workstation Card that is not currently in a session on the network. If …

How do I configure my 4 monitors in the PCoIP Zero Client OSD?

To configure 4 monitors to your preference, follow the steps below. Before you begin, make sure that you know what monitor is connected to what PCoIP Zero Client port number. From the onscreen display (OSD) of your PCoIP Zero Client, browse to Options > …

Troubleshooting artifacts in a PCoIP Session

Problem During a PCoIP Session artifacts are appearing on the screen. The artifacts may stay or slowly disappear. Cause and Resolution There are may reasons artifacts may appear on the screen. Some may be source issues such as the application or …

Display resolution, topology, image artifacts or rendering-performance issues in HP Anyware with a GPU

Symptoms If you are using HP Anyware's Graphics agents with a GPU, either Nvidia GRID or AMD FirePro, the following issues may be caused by incorrect GPU driver: Image tearing Image artifacts Slow connection times Display topology issues Low frame rates …

How to configure an Amazon Network Load Balancer (NLB) with the PCoIP Connection Manager and Security Gateway or HP Anyware Connector

The following article provides an example on how to setup an Amazon Network Load Balancer with the PCoIP Connection Manager and Security Gateway (CM/SG) or HP Anyware Connector (CAC). Prerequisites: Connection Manager & Security Gateway: 1. Deploy the …

Why is the BIOS not visible when my Dell workstation boots with a PCoIP Remote Workstation Card?

Scenario The BIOS on a Dell R5500/R5400 is not visible on boot up. After the OS loads, the monitor then displays the desktop. On some graphic cards, only the primary port is active during the POST phase of the host PC boot process. For example, when using …

Do PCoIP Zero Clients support single and multi-touch monitors?

Answer: PCoIP Zero Clients support selected ELO touch monitors in pre-session (using the Teradici OSD) since Firmware 3.4.0,and should support other touchscreen monitors (single and multi-touch) while in a PCoIP session. To make a connection using a …

Knowledge Base Article Advisory Display Zero Clients

Last modified: September 21, 2023

1515

What are PCoIP session variables for HP Anyware in Windows OS?

Answer: PCoIP Software Session Variables in Windows let you tune and configure a PCoIP session. Run gpedit.msc from a Windows Start -> Search menu. This will bring up the Local Computer Policy window. Navigate to " Computer Configuration -> …

Knowledge Base Article Advisory Session HP Anyware

Last modified: September 12, 2023

1427

Can a single PCoIP Software Client connect to multiple hosts simultaneously?

The PCoIP Software Client is only designed to connect to one PCoIP host. The PCoIP Software Client can be run multiple times on the same system to allow for multiple PCoIP sessions to multiple PCoIP hosts. The Teradici PCoIP Software Client provides a …

Knowledge Base Article Tutorial Session HP Anyware

Last modified: April 19, 2023

1401

Why is the BIOS not accessible from my PCoIP Workstation solution?

The BIOS must be able to enumerate the PCIe PCoIP Remote Workstation Card and support OHCI which typically does not occur until post BIOS. USB peripherals (keyboard, mouse etc.) connected to PCIe PCoIP Remote Workstation Cards as in a PCoIP Workstation …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics