Will out of order packets impact a PCoIP session?
PCoIP will work when packets are becoming out of order between the two PCoIP endpoints. Re-ordering packets on PCoIP endpoints requires that packets are held in a queue/buffer while waiting to receive the packets that need to be put back into order.  With …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
325
Why do I get poor performance on an MPLS network?
There are a number of configuration requirements for using PCoIP protocol on an MPLS network.  Prioritize PCoIP packets as a best practice Avoid packet loss Avoid out-of-order packets PCoIP protocol may consider out-of-order packets as lost if the data …
Knowledge Base Article Troubleshooting Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
311
Why doesn't the PCoIP Remote Workstation Card power up when it is installed to a particular PCIe slot?
This may be due to the restrictions of your host PC's motherboard that requires you to install graphics cards or other PCIe cards into certain PCIe slots. If a PCIe card is installed into an inappropriate PCIe slot, the host PC may stop loading any …
Knowledge Base Article Troubleshooting Setup Remote Workstation Card
Last modified: November 22, 2022
309
How do I ensure a fair allocation of bandwidth between multiple PCoIP sessions?
The PCoIP congestion avoidance algorithms are designed to ensure a fair allocation of bandwidth between multiple PCoIP sessions on the same network. There may be some networks where this doesn't work as well. There is also an associated time constant for …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card
Last modified: December 9, 2022
306
How does PCoIP share bandwidth over the network?
The BW Limit is dynamically calculated and represents the bandwidth the PCoIP session estimates to be available given the network conditions. The calculation takes into account the existing bandwidth usage, packet loss and any high latency spikes. The …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
292
Does PCoIP Protocol support half duplex networking equipment?
PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients
Last modified: July 3, 2020
272
Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Knowledge Base Article Troubleshooting Setup Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 20, 2023
265
How do I configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card?
There are three ways to configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card. Option 1: Use the PC NIC and PCoIP Host Software  For instructions, refer to How do I remotely power on the host PC/workstation through its network interface …
Knowledge Base Article Tutorial Setup Remote Workstation Card
Last modified: August 23, 2018
265