What network switch or router queue size should be used?
Network device queues, also known as network buffer's, should be configured to accommodate 50ms to 100ms of PCoIP protocol traffic in total. This assumes that one network device (e.g. switch or router) is congested for a given network path. If the network …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 19, 2023
665
Installing Management Console
After completing this unit, you’ll be able to: Install the HP Anyware Management Console, or Migrate to a newer version 25 mins   HP Anyware Management Console is released in three formats that feature CentOS as the PCoIP Management Console installation …
Knowledge Base Article Tutorial Management Setup Management Console
Last modified: August 2, 2023
669
How do I improve performance when dragging a window on the screen using firmware pre-4.1.0 and without a PCoIP Hardware Accelerator installed?
Problem While there are many factors that determine desktop performance - see  PCoIP TROUBLESHOOTING STEPS: VMware View Virtual desktop performance  - lower performance of window dragging may be observed in the following environment: VMware Horizon View …
Knowledge Base Article Troubleshooting Performance Zero Clients
Last modified: November 18, 2022
658
Encryption and bandwidth metrics used for various setups PCoIP Devices and VMware Horizon View
Answer:   Encryption and Bandwidth Metrics   Tera1 Zero Client Tera2 Zero Client Windows View Client Host Card No View Security Server Up to 220 Mbps AES-128 (not encapsulated) Up to 500 Mbps AES-128/AES-256| (not encapsulated/encapsulated) FW 4.1.0 and …
Knowledge Base Article Advisory Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 3, 2023
641
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
610
How do I disable login username caching on a PCoIP Zero Client?
On a PCoIP Zero Client, username caching is set in the advanced options and can be disabled from the OSD Screen, the Administrative Web Interface (AWI), or the PCoIP Management Console.    From the OSD Screen: Under Options, select Configuration In the …
Knowledge Base Article Tutorial Setup Management Session Management Console Zero Clients
Last modified: September 3, 2023
593
How to configure a PCoIP Zero Client to auto-connect to a Remote Workstation Card
Answer: To enable auto connect, you need to peer the PCoIP Zero Client to the Remote Workstation Card. You will need the IP and MAC of the host. You enter this in the PCoIP Zero Client's configuration (On Screen Display or Administrative Web Interface), …
Knowledge Base Article Tutorial Setup Remote Workstation Card Zero Clients
Last modified: September 14, 2023
576
Can I use an Ethernet hub or half-duplex network connection with a PCoIP Zero Client or PCoIP Remote Workstation Card?
No. PCoIP technology requires a full-duplex Ethernet connection from end to end. In modern networks, half-duplex links can still exist when using technologies such as Wi-Fi or point to point Wi-Fi or Microwave links. Older communication equipment in wired …
Knowledge Base Article Troubleshooting Performance Remote Workstation Card Zero Clients
Last modified: March 26, 2021
552
How does device discovery work with the PCoIP Management Console 2.x and 3.x?
The PCoIP Management Console must discover all of the PCoIP devices that it manages and therefore supports the discovery of devices using three mechanisms: DHCP Option discovery DNS DNS Service Record Discovery DNS-Based Discovery Prefix Manual Discovery …
Knowledge Base Article Tutorial Performance Management Console
Last modified: September 3, 2023
545