Why is the image quality reduced for a couple seconds right after a session is connected?
This is expected behaviour during the first couple seconds when a PCoIP session is established and is caused by the PCoIP device's bandwidth management algorithm. The algorithm continuously optimizes the amount of network traffic a PCoIP device generates …
Knowledge Base Article Troubleshooting Session Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 7, 2023
190
ICMP packets are being send from the machine at the start of the PCoIP session
Problem At the start of a PCoIP session a network trace or firewall logs are recording ICMP packet being sent from the machine. Further investigation shows they are from the PCoIP Server process. PCoIP server logs show a trace route log of up to 30 hops. …
Knowledge Base Article Troubleshooting Session Performance HP Anyware
Last modified: September 19, 2023
574
Are there any limitations on physical distance for a PCoIP session?
Due to the design of PCoIP, using UDP for data transmission, PCoIP will operate over vast distances and network latencies up to 250 ms. PCoIP intelligently acknowledges the traffic inside the protocol allowing for high speed transmission over high latency …
Knowledge Base Article Tutorial Session Performance HP Anyware Remote Workstation Card
Last modified: December 9, 2022
883
What does the error message "Session Closed Remotely" mean?
There are a number or reasons that the message "Session Closed Remotely" appears during a brokered session listed below. Informational Messages Closed by login at an alternate location or host shutdown/restart User initiated logout Disconnected by …
Knowledge Base Article Advisory Session HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
977
Configures the PCoIP transport header
Configures the PCoIP transport header with the following options: When set to Enabled , the configured session priority of high , medium , or low is used. When set to Not Configured , then the default of medium session priority is used. When set to …
Knowledge Base Article Tutorial Session HP Anyware
Last modified: September 19, 2023
577
Why can I not establish a PCoIP session when using (IDN) characters in my HP Anyware environment?
Answer: Internationalized Domain Names (IDNs) are not supported by the HP Anyware. In environments that use the HP Anyware PCoIP Connection Manager and Security Gateway, a PCoIP session will not launch when one or more IDN characters (i.e. ? ? ? ?) are …
Knowledge Base Article Troubleshooting Session HP Anyware
Last modified: September 19, 2023
224