Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

Why am I seeing high bandwidth from the PCoIP Zero Client for audio even though I am not recording anything?

Problem As soon as an audio application starts and samples data from the audio input, PCoIP traffic from the client to host increases significantly and is steady. Cause Once an application requests audio from the line in or microphone inputs, the PCoIP …

How is the bandwidth limit determined?

The PCoIP protocol determines the bandwidth limit by examining network conditions such as received bandwidth, latency, and packet loss. The PCoIP protocol adapts to provide the best user experience for the available bandwidth. When congestion is …

What are the limitations of configuring active directory with Management Console?

PCoIP Management Console 3.2.x has important limitations which need to be considered before using this feature in your deployment. Active Directory users must be assigned to a Security Group. Only supports one active domain at a time. Does not support …

Does PCoIP Protocol support half duplex networking equipment?

PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …

Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?

Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …

When the network experiences periods of high congestion what will happen to the users experience?

PCoIP will adjust to the network conditions to deliver the best PCoIP experience possible, for the given network conditions, for the user. During periods of congestion the user experience: A blurry or compressed image Momentary block screens Stuttering …

When are PCoIP session statistics reset on a PCoIP Zero Client?

Session statistics are reset at the start of each PCoIP session, i.e. when a session is connected. You can also reset them during a session through the AWI under Diagnostics, Session Statistics, Reset Statistics. … When are PCoIP session statistics …

Can I add software to or change the operating system of a PCoIP Zero Client?

PCoIP Zero Clients do not run local application software. They run secure custom firmware created by HP Anyware only. This makes them extremely secure PCoIP Clients allowing for simple management and updates through small firmware updates. New features …

Knowledge Base Article Tutorial Setup Zero Clients

Last modified: September 22, 2023

249

Does the TERA2321 support the SGMII interface for a copper SFP?

Answer: No. The Tera2321 only supports MII (10/100Mbps) or RGMII (10/100/1000Mbps) copper/fiber interfaces. Definitions : SGMII - Serial Gigabit Media Independent Interface. RGMII - Reduced Gigabit Media Independent Interface. MII - Media Independent …

Random individual and mass client disconnects due to Cisco VSS Inter-switch links

Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops. Cause There have been observed …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics